logo3.23.20.png
PG1_FINAL_edited.jpg

Thoughtfully designed

Skillfully engineered

Designed to make an already great car better, the PF-1 builds upon the Tesla Model 3 & Y brakes by increasing width, separating the tophat, and using aerospace grade materials and surface finishes

 

The PF-1 brings a whole new level of performance to your brakes. 
 
Thanks to an improved directional vane design the PF-1 sustains higher performance for longer periods of time. This means more speed in the straights and less worrying about brake fade.

PG2_FINAL_edited.jpg

More stopping less fading

Cooling

 

7075-T6

Aluminum

MIL-A-8625

Anodized finish

GG20 

Friction ring 

26mm

Thickness

___DSC7613-Recovered2_edited.jpg
 
 8%
increase in specific heat capacity
and it doesn't stop there...

Aerospace grade materials like 7075-T6 aluminum for the tophat saved over 1lb of total rotational mass.

By going bigger our rotors capacity increased from 3900  to nearly 4200 joules. 

UP-1
4200 joules
gradient2.png
STANDARD ROTOR
3900 joules

Balance

Forget about vibrations

PG4_Final_edited_edited.jpg

Each disc is high speed balanced at nearly 1000rpms giving your car the smoothest ride possible.

 

No detail overlooked

When it came to surface treatments nothing was overlooked. A MIL-SPEC III Hard Anodized finish is applied to every tophat and an aluminum zinc oxide coating to the friction ring giving the PF-1 superior wear resistance on and off the track

Surface

Slotted not dotted

Six 1mm deep slots and surface coatings remove spent pad material and keep your brakes protected giving you a consistent pedal feel on every push.

FINALPAGE_edited_edited.jpg
 

Wheels

Your Ride Your Wheels

The forged aluminum tophat provides added strength while also covering the stepped hub lip allowing the use of aftermarket wheels without modification to the hub bore.

Keep in touch to hear about future  products 

Thanks for submitting!